Custom wall holder and leg cap

BetaBeta version. Check the file in your slicer before printing. Found a problem? Contact us.

U-shaped wall holder sized to your remote, small router or phone, and caps/plugs for chair legs and tubes. Type the measurements, preview in 3D and get the STL.

How it works — watch the video

1Choose U holder or cap/plug.
2Measure the object and type the sizes.
3Download the short fit test first, then the full part.

Object widthmmObject thicknessmmFront lip heightmmBack heightmm 2 screw holes (4.5 mm square tunnel)

Color: Light blue

Fine tuning

WallmmClearance per sidemm

Part: 27 × 63 × 51 mm

Create a free account and get 1 download from any tool, in any format.

Short version, just to test the fit and clearance on YOUR printer before the full part.

Prints on its side (U on the bed), no supports.
To hold light devices only. No heavy loads or heat; not an insulator or electrical part.
3.5–4 mm pan-head screws or a washer; or double-sided tape.

Sizes and clearances vary with material, printer and slicer. Not for parts that get hot, are under pressure or heavy load, or as an insulator or electrical component.